Namecoin can be used for name resolution with Tor. This guide covers how to set this up using ncprop279 and StemNS.

Warning: this is beta software, and is not suitable for production use. It is being made available for testing purposes only. It’s using experimental API’s that may be replaced or removed in the future, and it will make your Tor client stand out from everyone else.

Install Tor

Hopefully you’ve already done this. Note that these instructions are not tested in any way with Whonix, Tails, or Subgraph OS; such systems use control port filters that may cause problems.

Install a Namecoin name lookup client

This could be either Namecoin Core or ConsensusJ-Namecoin. Note that if you’re using Namecoin Core, you may wish to make Namecoin Core route its traffic over Tor (this procedure should be identical as what you’d do for Bitcoin Core). ConsensusJ-Namecoin doesn’t yet support routing its traffic over Tor. If you’re using ConsensusJ-Namecoin, it is strongly recommended that you use leveldbtxcache mode (this is the default if you’re running the shortcut created by the ncdns for Windows installer; it is not the default if you’re running it from the command line); this is because the other modes will generate network traffic that isn’t subject to stream isolation. Electrum-NMC is not recommended because it will generate network traffic that isn’t subject to stream isolation.

Install ncprop279

ncprop279 can be downloaded at the Beta Downloads page. The build is not yet reproducible.

If you want to build from source:

go get

Install StemNS

StemNS is available on GitHub.

The _service_to_command configuration in should look like this (fill in the path to where your ncprop279 binary is located accordingly):

_service_to_command = {
    "bit.onion": ['/path/to/ncprop279'],
    "bit": ['/path/to/ncprop279'],

If you’re using Tor Browser Bundle, or are otherwise using a non-default Tor control port, you’ll need to update the control port in

Configure Tor

Tor must be configured with the following option:

__LeaveStreamsUnattached 1

In a typical Tor Browser installation, torrc-defaults is the correct place to add this option.

Running it

Make sure that the name lookup client and Tor are running. Then, run python3 in the StemNS directory. It should automatically configure Tor to use Namecoin for any domain name lookups that end in .bit or .bit.onion. Here’s a screenshot of the Tor example rendezvous points page:


Semantically, .bit.onion means that a domain name will always resolve to a .onion address (meaning that .bit.onion names are encrypted and authenticated regardless of whether TLS is used); .bit means that a domain name will resolve to any of .onion, IPv6, IPv4, or CNAME, meaning that .bit names are only encrypted and authenticated if TLS is used. These semantics are open to revision later, as the Tor community evolves its canonical naming semantics.

Namecoin name owners can specify a .onion domain via the txt field in the _tor subdomain of their name. This specification is open to revision later, as the Tor community evolves its canonical naming specifications. (In particular, it is possible that TXT records might be replaced with SRV records.)